Written by LSE

X•PAD Survey & PicPoint

PicPoint is the innovative way of measuring points not directly accessible from the GPS. The combination of GPS positions with the photos acquired by a calibrated camera positioned on the pole, allows to measure directly in the field new points directly on the photo.

Read More
0
Written by LSE

X•PAD & new Zenith35 TAG

X•PAD 3.0 is able to support the new firmware available for the GeoMax Zenith35 TAG receiver that allows you to use internal compass, not just inclinometer.

Read More
0
Written by LSE

X•Pole: one pole, two systems

X•Pole solution available in X•PAD Survey and Construction 3.0 allow you to work simultaneously with TPS and GNSS using the best features of each system as required and with maximum flexibility.

Read More
0
Written by LSE

X•PAD AutoMeasuring module

XŸ•PAD TPS AutoMeasuring is a new module of XŸ•PAD Survey software that allows to perform automatic or single measuring sessions on a set of defined points. The system can be configured to execute automatically the orientation to control points and then measurement on a list of defined points; the reports of the measuring session are then sent directly to an FTP server or attached to an e-mail.

0
android module xpad
Written by LSE

X•PAD Android Roading module

XŸ•PAD Roading is a new module of XŸ•PAD Survey software that allows to manage road design data in the field and perform all the necessary stakeout operations without to use point coordinates but by using original design data. The user is free to stakeout and to have road design information at any stations.

Road design data can be imported from LandXML format or from local road design software data format and the complete design can be managed directly on the controller; it is possible to manage more than one axis at the same time and all design data are displayed in plan view, longitudinal profile view and cross-section view.

0
news header 2
Written by LSE

X•PAD & Zenith35 TAG

The X•PAD Survey software is able to support the new GeoMax Zenith35 TAG receiver (Tilt & Go). The new receiver is equipped with a sensor capable of measuring very accurately the antenna tilt, and this feature has been used within the X•PAD software to improve the measurement activity in the field.

During the measurement, an electronic bubble appears on the screen and then you do not need to check continuously the bubble positioned on the pole but all the necessary information are present on the controller display.

news tag

It is possible to configure the software to not record epochs when the pole is out of the bubble; in this way you can change the traditional order of the measurement operations; In fact, you can press the button Measure and then bring the pole levelled. Only when the pole is vertical epochs will be captured and recorded point. The slope values of the pole at the time of the registration are stored.

It is also possible to measure inaccessible points such as edges, walls, poles using the double measure with the inclined pole that guarantees precision and speed of execution.

0
Written by LSE

X•PAD3D for Zoom3D

XŸ•PAD 3D is the LSE software for the new measuring instrument GeoMax Zoom3D. Thanks to its simple setup and auto levelling function, the Zoom3D is the plug-and-play solution that speeds up all your work indoors and in the outdoor construction site.

Its user-friendly onboard software helps with a wide range of indoor applications such as measuring, setting out or plumbing points. Levelling can now be completed with greater ease and speed, then exported in most common file formats.

For outdoor tasks, the Micro Robotic Solution is equipped with target recognition technology that automatically and easily centers and follows the target, allowing surveys and stakeouts in small construction sites.

GeoMax Zoom3D Series

GeoMax Zoom3D Series – applications

tag-news-4

0